Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Flowood, MS

Opener Gear & Sprocket Replacement in Flowood, MS

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Garage doors rarely fail at a convenient time. If you need opener gear & sprocket replacement in Flowood, MS, we can often come out the same day when a technician is available. Stripped drive gears replaced so the motor moves the door again.

When to call for opener gear & sprocket replacement

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Common causes

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

Safe checks before you call

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

How much does opener gear & sprocket replacement cost?

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Flowood, MS and nearby towns

A closed garage in a Mississippi summer gets very hot, which shortens the life of opener circuit boards, capacitors and photo-eye sensors. Storms add power surges, so a surge protector is cheap insurance.

Besides Flowood (ZIP code 39232), we handle opener gear & sprocket replacement in Pearl (2.5 mi), Jackson (2.8 mi), Richland (5 mi) and Ridgeland (8.2 mi). Call (833) 435-8883 to book a visit in Flowood.

Opener Gear & Sprocket Replacement: frequently asked questions

How much does opener gear & sprocket replacement cost in Flowood, MS?

Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Mississippi or Flowood requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Flowood, MS

Raynor Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Ryobi Opener Circuit Board Replacement

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $175-$400

Wind-Rated Garage Doors

Hurricane-rated doors and reinforcement kits for high-wind and coastal areas.

Typical $1,800-$6,000

CHI Overhead Doors Off-Track Garage Door Repair

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $175-$450

Sommer Garage Door Opener Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $125-$350

Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

CHI Overhead Doors Torsion Spring Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $200-$450

Wayne Dalton Garage Door Installation

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $1,200-$4,500

Ideal Door Garage Door Cable Repair

Frayed, snapped or slipped lift cables replaced and the door re-leveled.

Typical $150-$350

Holmes Garage Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Garaga Garage Door Cable Repair

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$350

Martin Door Garage Door Track Repair

Bent, loose or misaligned tracks straightened, realigned or replaced.

Typical $150-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Flowood, MS now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote